1. According to the decoration drawing designed by the engineer, the wall surface is leveled and pretreated, and the middle part is used, ruler, cutting machine, hammer and nail.
2. Cut the Marble UV Board according to the actual size.
3. Remove the spliced sheet and apply it with structural glue. Two application methods 1. All uniform whole plate application. 2. Apply at a fixed point.
4. The edge and marble lines are used together to design the overall effect!
5. Use of trimming machine. This process is to see the master technology, there are some young and inexperienced masters doing the repair is very bad, affecting the overall effect.
6. Finally, tear off the protective film of the High Glossy Marble UV Board decorative sheet finish.